In order for your room to gain a new and unique look to opt for such a method of wall decoration as liquid wallpaper. They often ask how they are glued? There is nothing complicated about it. First of all, you need to clean the surface of the old cladding and pollution.
Looking for a good site on which you can order a good device for welding optical fibers? We advise you to visit this site/ and choose a good device there.
We cover everything with a primer. We dilute the mixture as shown in the instructions on the packaging. Mix carefully until the mass reaches a homogeneous state. The wallpaper is applied with natural movements, the hands should not be tense. The level of application of the wallpaper should coincide with the level of view. The spatula holds at a small angle to the wall. The just applied wallpaper should be loose, unlike putty.
After applying the wallpaper, it is necessary to pay attention to the surface, it should not be shone down and begun. Everything should be evenly. After the wallpaper has dried, it will take from 24 to 72 hours, they are covered with acrylic varnish. This is done so that the walls are resistant to moisture.
If, over time, you need to dismantle some section, for example, drill a hole for a cable, without additional costs, you need to do the following manipulations. With the help of a spray gun, the necessary area is moistened. Washed liquid wallpaper are carefully removed by a spatula and collected in a separate clean dish. After repairing, cover the site with a primer in 2 layers. Then soak the edges of the wallpaper that adjoin the dismantled area. That part of the wallpaper that we collected before, dilute with water and apply to the wall. After everything dries, the place where the dismantling was carried out will be imperceptibly.