Restoration of the balcony slab
Quite often, people think that the repair of the balcony includes its internal and external finishes, as well as glazing (good, the metal -plastic windows Kyiv are now quite inexpensive, and therefore almost everything is installed) and, at best, the end of the loggia, but few people think that the restoration of the slab is also included in the repair, on which the loggia is held (to find out more about all the services that are included in the repair of the loggia, follow the link of the turnkey Balcony Kyiv and study the proposals and study the proposals. which are there).
Why are cracks and defects on plates appear?
Quite often, various cracks and defects may appear on the stove, and because of this, the use of such a loggia becomes unsafe. The best option in this case is the strengthening of the balcony slab, and the restoration depends directly on the condition of the plate and can be performed as follows: 1. Removing with a cement screed of cracks, which allows you to strengthen the stove if it has minor damage such as small cracks and flaws. The cement screed enhances the stove, but first it must be cleaned of dirt, and then aligned with the help of cement of its surface. In this case, it must be borne in mind that alignment should be with a slight slope into the outer value, and for additional strengthening the stove, it is necessary to use the following method: pour a thin layer of dry cement to the screed, which is then leveled, and then wait until the cement dries (wait for the cement (wait It will take about two days, and it is impossible to use loggia these days, otherwise you can damage the coating). 2. Installation on the loggia of a new reinforcing mesh is used when the plate is significantly damaged and has lost its bearing capacity.
How to do with a balcony stove in this case?
In this case, the rods of the nets are welded together or simply binded by wire, and when installing the reinforcing mesh, a gap is left between the stove itself and it, t.to. Subsequently, cement is poured into it (remember that the thickness of the cement layer should be almost doubled by the thickness of the grid). If the reinforcing mesh has been corroded, it is necessary to strengthen it with steel beams, which will be attached to both sides of the loggia to the wall, which will not only strengthen the stove well, but also slightly expand the area of the room (no more than 45 cm). 3. The stove can also be strengthened with the help of special ribs of stiffness located over the entire area of the plate under it, and after installing them you can install a warm floor that will allow you to feel on loggia or balcony quite comfortable and comfortable at any time of the year.