If you have one room in a summer house, then it is worth dividing it into zones and choosing the interior is not necessary in the same style.
First, prepare the walls, ceiling and floor. From the walls we will remove the old wallpaper (if they were) or if it is a log house, then fabricate the logs and treat them with special impregnations. A bright wooden lining will look very good on the walls and ceiling. If you need to replace sewer pipes, then it is worth installing pipe from polypropylene. Since the replacement of pipes with polypropylene is very profitable.
To begin with, we cover the lining with special protecting agents, they prevent wood from decay, mold and the appearance of harmful insects. After processing it, it must be dried and brought into the house for a day. This is done so that the lining is not subsequently dry and does not give a shrinkage. We will attach the lining to the crate. It is attached to the wall using screws or screws with the same interval of about 45-65 cm. The design must be aligned with the help of a building level, plumb line, etc. Between the wall and the cladding, it is necessary to leave the gap. It will serve as a ventilation space. There are several ways to attach the lining. We will use hidden installation – this is a more complex, but neat way. We will beat with nails in the puzzles of the lining itself. At the same time, the fastenings are practically not visible. We sheathed the room with lining. A wooden parquet will look good on the floor. We unpack the parquet and fold the boards in the place where the floor will. It is important to accurately determine the center of the room, for this you need to measure the width of the room and the middle is marked with a cord. Next, you need to outline another line 2-2.5 cm from the wall, from which you start the flooring (place for skirting boards). On the line that we outlined, we will lay the first row, align it and fasten it with self -tapping screws or screws so that then after installing the baseboard, the screws were not visible. We will put the following rheck rows into the groove of previous rails and also be attached with screws. The last row, like the first, is fixed from the side of the wall. The length of screws or screws should be thicker than a rail of 2 – 2.5 times. By laying the slats, we must press them tightly. Fix them with screws to all lags. In this case, the mount will be of high quality. Next, fasten the baseboard. Our room is ready. We stop the division of the room into the zones and rooms of the room.